3. Remove the socket by turning it
counterclockwise and pull it out.
4. Pull the old bulb straight out.
5. Push the new bulb into the socket.
6. Push the socket back into the assembly.
Tighten the socket by turning it clockwise.
7. Reinstall the assembly with the two screws.
License Plate Lamp
To replace one of these bulbs, do the following:
1. Turn the lamp assembly counterclockwise and
pull the lamp assembly out of the connector.
2. Pull the old bulb from the lamp assembly,
keeping the bulb straight as you pull it out.
3. Install the new bulb.
4. Reverse Steps 1 through 3 to reinstall the
license plate lamp.
346
Replacement Bulbs
Exterior Lamp
Back-Up Lamp
Front Parking/Turn Signal Lamp
License Plate Lamp
Headlamps
High-Beam
Low-Beam
Sidemarker Lamp
Stoplamps, Taillamps, and
Turn Signal Lamp
For replacement bulbs not listed here, contact
your dealer.
Bulb Number
921
3157NAK
194
H9
H11
194
3057