Stabilizer Bracket; Carriage Bolt (5/16 X 3/4 Inch); Locknut (5/16 Inch); Self-Tapping Screw (5/16 X 3/4 Inch) - Toro 79410 Operator's Manual

3
Installing the Attachment
Mount
Parts needed for this procedure:
1

Stabilizer bracket

2

Carriage bolt (5/16 x 3/4 inch)

4

Locknut (5/16 inch)

2

Self-tapping screw (5/16 x 3/4 inch)

2

Bolt (5/16 x 1 inch)

1

Pivot frame

2

Hairpin cotter

2

Rod

2

Washer

Installing the Stabilizer Bracket
and Pivot Frame
1. Install the stabilizer bracket to the engine guard
using 2 carriage bolts (5/16 x 3/4 inch) and 2
locknuts (5/16 inch)
1. Carriage bolt (5/16 x 3/4
inch)
2. Install the pivot frame to the machine frame as
shown in Figure 6. Secure the pivot frame to the
machine frame using 2 bolts (5/16 x 1 inch) and
2 locknuts (5/16 inch).
(Figure 5).
Figure 5
2. Locknut (5/16 inch)
1. Locknut (5/16 inch)
3. Secure the pivot frame to the bottom of the
machine frame using 2 self-tapping screws (5/16
x 3/4 inch) as shown in
1. Self-tapping screw (5/16 x 3/4 inch)
4. Install the bent, flared end of a rod into the keyed
g300204
slot in the left side of the machine frame, and
move the rod rearward to seat it in the frame
(Figure 8).
Note:
Repeat this step for the right side of the
machine.
7
Figure 6
2. Bolt (5/16 x 1 inch)
Figure 7.
Figure 7
g300205
g300206