Table of Contents
Advertisement
3
General
This operating manual contains all necessary instructions for the installation, commissioning, operation and
maintenance of the evaluation board mpSmart-Flowstop controller. The manual is intended to help you achieving
optimal results in a short time and shall assist avoiding possible sources of errors. The operating manual of the
micropumps and other controllers are available separately.
The products have been designed with state-of-the-art technology and in accordance with all relevant safety
regulations. However, a risk of damage to the units, other property, the operator and/or other persons cannot be fully
excluded.
Always ensure that specialized and trained personnel will comply with the following general instructions.
Therefore, please keep this manual and hand out copies as required.
Bartels Mikrotechnik GmbH rejects any responsibility for damages to persons or property resulting from non-
compliance with the instructions in this manual. In this case all warranties shall be void.
Declaration of conformity.
Bartels Mikrotechnik GmbH declares that the products are compliant to the RoHS directive 2011/65/EU. The controller
complies with the requirements of EMV 2014/30/EU and CE markings have been affixed to the devices. Additionally,
the controllers are also compliant to the EU Low Voltage Directive 2014/35/EU.
Description of function.
The mpSmart-Flowstop have been developed for the transport of liquids. The controller has been developed for
operating the micropump. Bartels Mikrotechnik can assume no liability for damages resulting from the pump media.
This applies especially for hazardous fluids.
The pump must be operated with Bartels Mikrotechnik electronics. Bartels Mikrotechnik GmbH cannot guarantee the
proper work of the units with customer specific electronics. If other controllers than the ones from Bartels
Mikrotechnik are used, Bartels Mikrotechnik disclaims any warranty.
Moreover, please note that components of the controller and pump are operating with high-voltage.
Therefore,
persons wearing pacemakers are recommended to avoid the operating system.
Bartels Mikrotechnik assumes no liability for abnormal handling, improper or negligent use of the micropump and
the controller that is not conform to the specified purpose of the system. This applies especially for micropump
controllers, components and systems of other manufacturers, which have not been certified by Bartels Mikrotechnik.
We guarantee that the micropumps comply with the actual state of scientific and technical knowledge and due to
this, the operational risks are limited to a minimum.
Do not open the housing of the micropump and the controllers.
In those cases, Bartels Mikrotechnik cannot issue a
guaranty anymore. Please keep this manual safe and give a copy to all users.
Rev. 1.1 (02.2021)
Advertisement
Table of Contents
