1. Manuals
  2. Brands
  3. Bartels Mikrotechnik Manuals
  4. Controller
  5. mpSmart-Dosing
  6. Instruction manual

Bartels Mikrotechnik mpSmart-Dosing Instruction Manual

Flow controlled system
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
1
Flow Controlled System –
"mpSmart-Dosing"
Rev. 1.4 (01.2021)

Advertisement

Table of Contents
loading

Related Manuals for Bartels Mikrotechnik mpSmart-Dosing

Summary of Contents for Bartels Mikrotechnik mpSmart-Dosing

  • Page 1: Flow Controlled System

    Flow Controlled System – “mpSmart-Dosing” Rev. 1.4 (01.2021)

  • Page 2: Table Of Contents

    Flow Controlled System – ..................................1 “mpSmart - Dosing” ....................................1 General ..........................................3 Declaration of conformity..................................3 Description of function..................................3 Proper use ........................................4 Intended purpose..................................... 4 Misuse......................................... 4 Staff selection and qualification................................ 4 About this operating manual.

  • Page 3: General

    EU Low Voltage Directive 2014/35/EU. Description of function. The mpSmart-Dosing have been developed for the transport of liquids. The controller has been developed for operating the micropump. Bartels Mikrotechnik can assume no liability for damages resulting from the pump media. This applies especially for hazardous fluids.

  • Page 4: Proper Use

    Do not make any modifications or extensions to the pump or controller without the prior written consent of the manufacturer. Such modifications may impair the safety of the unit and are prohibited! Bartels Mikrotechnik GmbH rejects any responsibility for damage to the unit caused by unauthorized modifications to the pump and risk and liability are automatically transferred to the operator.

  • Page 5: The Flow Controlled System: Mpsmart Dosing

    The flow-controlled system: mpSmart-Dosing This Flow Control System is a smart module for precise and regulated dosing of liquids. An on-board Arduino reads out a flowmeter made by Sensirion, comparing it to a target value and operates the mp6 micropump corresponding to a PID-regulator. The attached PC-software can be used to monitor, control and log the flowrate.

  • Page 6: Getting Started With Mpsmart

    SLF3S-1300F sides which are included in the mpSmart-Dosing (UP D-646; Swivel Barb Adapter, 1/16" ID Tubing). As for the tube lengths between mp6 micropump & mp-damper or mp-damper & we recommend at least 50 mm.

  • Page 7: Starting The Evaluation Software

    Port. When selected click on „Connect“ to start the communication between the program and the driver. If the device was not found you might need to install the driver for the Arduino nano microcontroller manually. To start your mpSmart-Dosing all you need to do is to choose one of the four flowrate ranges, e.g. 4500 – 8000 µl/min.
  • Page 8 Afterwards the mp6 micropump can be started or stopped with the on or off button. The current flowrate is displayed underneath or as a time plot on the right of the Evaluation software. Rev. 1.4 (01.2021)
  • Page 9 All values are approximate and no guarantee of specific technical properties. Changes in the course of technical progress are possible without notice. Visit our Website Contact Data: www.bartels-mikrotechnik.de/produkte/downloads Bartels Mikrotechnik GmbH Konrad-Adenauer-Allee 11 for further information on applications. 44263 Dortmund Germany Tutorials and helpful answers to frequently asked www.bartels-mikrotechnik.de...

Table of Contents