Table of Contents
Advertisement
Watching TV
z For a complete list of all
the functions of the
remote control, see page
56.
64
To Do This ...
Activate the remote control to
operate the TV
Turn on/off the TV
Tune directly to a channel
Adjust the volume
Mute the volume
Alternate back and forth between
two channels
Display the current channel
number (and other information)
Switch the TV's input to the VCR,
DVD player, or other connected
equipment
Change video and audio options,
customize the TV's setup, set
parental controls, and more
Switch the TV's input between
sources connected to the TV's
VHF/UHF and CABLE inputs
Depending on the weather and receiving condition, Block Noise
(the square-shaped image distortion) may occur while watching
digital channels.
Do This ...
TV
(FUNCTION).
Press
Press 1.
To tune to analog channels, press
ENT
(or wait 3 seconds).
For digital subchannels, press 0-9,
0-9
again, and then ENT.
For example, to select subchannel 2.1, press 2,
, 1, and then press ENT.
You can also select channels using
the program guide. See page 65 for
details.
Press
VOL
+/–.
MUTING
Press
(press again or
unmute).
Press JUMP.
The TV alternates between the current channel
and the last channel tuned.
Press
DISPLAY
once to display the channel
number, current time, wide mode, and channel
DISPLAY
label (if set). Press
Display off.
TV/VIDEO
Press
repeatedly to cycle through
the video equipment connected to the TV's
video inputs.
Press
MENU
to display the Menu. For details,
see "Using the Menus" on page 91.
Press
ANT
to alternate between sources
connected to the TV's VHF/UHF and CABLE
inputs.
0-9
and then
, press
VOL +
to
again to turn
Advertisement
Table of Contents
