Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink
."
Resetting Defaults
®
To reset HomeLink
to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
1-800-355-3515, or on the internet at
www.homelink.com.
®
®
®
using a HomeLink
®
button.
®
®
®
at
Storage Areas
Glove Box
To open your glove box, lift the lever on the front of the
glove box and lower the door.
Overhead Console
If your vehicle has this feature, the overhead console
includes reading lamps, a compartment for a garage
door opener, a temperature and compass display and a
storage compartment for sunglasses.
2-49