Disassembly Procedure - ViewSonic VP3881 User Manual

8. Disassembly Procedure

1. Take out the monitor from the HDPE bag and put the monitor
on a protective cushion. Use a Phillips-head screwdriver to
remove the four screws to unlock the stand.
2. Use a small slot screwdriver to insert between the two gaps
(marked as No.1~2) on the bottom side of the rear cover
to pry up the rear cover. Use one hand to press the panel
module, the other hand to pull up the rear cover in order of
arrow reference for unlocking the mechanisms of the rear
cover. Remove the rear cover.
3. Put the rear cover on a protective cushion, tear off the mylar
tape, then use a Phillips-head screwdriver to remove 3
screws to release the function key board.
4 Tear off 2 aluminum foil pieces to release the bracket from
the panel module. Tear off the PVC tape and then disconnect
the LVDS cable from the connector of the panel. Disconnect
the panel power cables from the connector of the panel
module.
5
Tear off 2 pieces of black PVC tape to release the speakers'
cables, then release the speakers' cables from the hooks of
the middle bezel. Use a Phillips-head screwdriver to remove
4 screws to unlock the two speakers; then release the
speakers from the probers and disconnect the audio cables
from the connector of the audio board.
6
Use a Phillips-head screwdriver to remove 18 screws to
unlock the middle frame with the panel module. Remove the
middle bezel.
67