Self Clean Operation; Preset Operation - Mitsubishi SRK20ZSXA-W User Manual

SELF CLEAN operation

■ SELF CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside of the indoor unit and
control the growth of mold and bacteria.

PRESET operation

■ This operation can save the preferred setting for future operation.
RLF012A204_EN_1-36.indd 29 RLF012A204_EN_1-36.indd 29
1
Select the SELF CLEAN operation by pressing the
MENU switch.
2
Select SELF CLEAN on by pressing " or
button.
(SELF CLEAN off)
3
Press the SET button.
NOTE
• Two hours later, the air-conditioner stops SELF CLEAN operation
automatically. To stop the air-conditioner immediately, press the ON/OFF
button.
• SELF CLEAN operation is not operated after HEAT, FAN, OFF TIMER,
SLEEP and ALLERGEN CLEAR operations have finished.
• The indoor unit fan runs for about two hours in SELF CLEAN operation.
• The RUN light illuminates during SELF CLEAN operation.
• Pressing the SLEEP button, ALLERGEN CLEAR button or NIGHT
SETBACK button during SELF CLEAN operation cancels the SELF
CLEAN operation and then the unit is set to SLEEP, ALLERGEN CLEAR
or NIGHT SETBACK operation.
• This is not a function for removing mold, germs or grime that have
already adhered to the unit.
1
Select the PRESET operation by pressing the MENU
switch.
2
Select preferred OPERATION MODE, TEMPERATURE,
FAN SPEED and AIR FLOW direction.
3
Press the SET button.
4
When air -conditioner is operating AUTO, COOL, HEAT,
DRY, FAN and NIGHT SETBACK, press MODE button 3
seconds or more. PRESET operation will start.
NOTE
• When pressing MODE button for PRESET operation during the 3D
AUTO or HIGH POWER operation, it will be canceled.
• When pressing MODE button for PRESET operation during the
ECO operation, it will continue.
– 29 –
(TIMER)"
(SELF CLEAN on)
3 seconds
ON
OFF
1 second
7/29/2017 6:11:40 PM 7/29/2017 6:11:40 PM