Table of Contents
Advertisement
6. The product detects the wired connection,
verifies the network connection, and then
connects to the network.
7. Press the
(OK) button.
Wired - Manual
Ğ
If you have a static IP address or the Automatic
procedure does not work, you'll need to set the
Network Settings values manually.
Follow Steps 1 through 3 in Wired - Automatic,
and then follow these steps:
1. Select Network Status. The product
searches for a network, and then displays the
connection failed message.
2. On the bottom of the screen, select IP
Settings, and then press the
The IP Settings screen appears.
3. Select the IP Settings field, and then press
the
(OK) button.
4. Select Enter manually in the IP Settings
field, and then press the
5. Select a parameter to enter (IP Address, for
example), and then press the
Use the Up/Down buttons on the remote
control to enter the numbers for the
parameter.
Use the Left/Right buttons on the remote
control to move from entry field to entry field
within a parameter. When done with one
parameter, press the
6. Press the Up or Down button to move
to another parameter, and then enter the
numbers for that parameter following the
instructions in Step 5.
7. Repeat Steps 5 and 6 until you have filled in
all parameters.
| NOTE |
\ You can get the Network parameters from your
Internet provider.
8. When finished entering all the parameters,
select OK, and then press the
The product verifies the network connection
and then connects to the network.
(OK) button.
(OK) button.
(OK) button.
(OK) button.
(OK) button.
27
English
Wireless Network
You can set up a wireless network connection in
four ways:
- Wireless Automatic
- Wireless Manual
- WPS(PBC)
- WPS PIN
When you configure the wireless network
connection, any wireless network devices currently
connected through the product or, if applicable,
the product's current wired connection, will be
disconnected.
Wireless - Automatic
Ğ
1. In the Home screen, select Settings, and
then press the
(OK) button.
2. Select General, and then press the
button.
3. Select Network, and then press the
button.
4. Select Network Settings, and then press the
(OK) button.
5. Select Wireless in the Network Type screen,
and then press the
Wireless Connection
iptime23
iptime
solugen_edu#2
Refresh
6. Select the desired network, and then press
the
(OK) button.
| NOTE |
\ Alternatively, select Add Network at the
bottom of the wireless network list to establish
a connection. This method can be used when
you know the SSID (name) of the wireless
router.
(OK)
(OK)
(OK) button.
Advertisement
Table of Contents
