Procedure; Setup And Configuration Verification - TC Communications TC1920 User Manual

Chapter 3 Quick Start Guide
3.3

Procedure

This section will guide you through the basic setup and initialization for a pair
of TC1920 units.
NOTE
To install and setup the units
1. Set Unit #1 as Master by setting dip switch 1 to MSTR (up position).
Set Unit #2 as Slave by setting dip switch 2 to SLVE (down position).
2. Power up both units.
3. After booting is complete, each unit should be running at their
respective default pairing modes (as set by the dip switches).
3.4

Setup and Configuration Verification

The following procedure helps you determine if there are any corrections to
be made to the setup.
To verify the unit installation
1. Connect the TC1920 units' P1 ports together through an Ethernet
connection with phone stations connected to TC1920 Phone/Line ports.
2. The BP1 LEDs of each unit should turn on and flash occasionally.
3. After a few seconds, the unit should indicate that their are linked with
one another.
4. Check the following LEDs to verify both units are operating properly:
RDY
LINK
FXS
MSTR
SLVE
HT-L
5. FXS ports will perform a quick ring test after initialization has
completed.
3-2
The following procedure assumes that the units have been
restored to default, and are running factory default settings.
Solid ON
Solid ON
Solid ON
Solid ON (Unit 1 Master)
Solid ON (Unit 1 Slave)
Solid ON
1.0
Procedure
TC1920 Rev 1.3 User Manual