iFIT TF 300 User Manual page 10

MAKING ADJUSTMENTS USING THE BUCKLE
1. Once buckled, stand up to test out the tightness.
2. If too tight or too loose, return to a seated position.
3. Move the cable 1-2 notches either forward or backward until
the right fit is achieved.
4. Once you find a snug fit, you can also mark this notch with a marker
if needed. We have found a silver marker works well.
Important
If you notice any excessive movement of the limb inside the socket,
contact your prosthetist immediately. Many persons with amputation
shrink in size and may need their prosthesis adjusted by the prosthetist.
TAKING OFF THE PROSTHESIS
1. Always begin in a seated position.
2. Press the safety latch on the buckle rearward in order to lift the buckles
and unbuckle the cables.
3. Press the pin release button located on the lower lateral side of the
prosthesis. This button is recessed and must be held down while the limb
is pulled out of the prosthetic.
4. The limb should slide out easily. If you are having difficulty make sure you
are sliding the prosthetic off in the direction of the pin- otherwise the pin
will be caught at an angle. One way to accomplish this is by buckling the
middle buckle, then pushing the release button.
10