1. Manuals
  2. Brands
  3. Atec Manuals
  4. Toy
  5. 321 FAETA NG
  6. Assembly and disassembly

Atec 321 FAETA Assembly And Disassembly

Hide thumbs Also See for 321 FAETA:
1
2
3
4
5
6
7

Advertisement

Table of Contents

ATEC 321 FAETA NG – tailplanes assembly and disassembly
 One person is needed for assembly/disassembly of the tailplanes.
 All parts needed for assembly are delivered together with the aircraft.
 Do not push hardly on any surface during manipulation to avoid cracks in the gel-coat (especially in the
area of dividing lines, edges, non-reinforced areas).
 For each next assembly, it is necessary to replace locking nuts with new ones.
 Pay attention to avoid a fall of small parts into the inner space of the tail fin during manipulation!!
Tailplanes assembly / disassembly
a) Horizontal tailplanes (HT) installation
 In case the aircraft is delivered with the vertical tail rudder already installed, it is necessary to remove
it to reach the access to attachment points of the horizontal tailplane attachments. For disassembly
instructions see the part b) on the Page 7.
 Prepare the tailplanes for assembly (2 halves of horizontail tailplane and vertical tail rudder):
1 of 15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 321 FAETA and is the answer not in the manual?

Questions and answers

Related Manuals for Atec 321 FAETA

Summary of Contents for Atec 321 FAETA

  • Page 1 ATEC 321 FAETA NG – tailplanes assembly and disassembly  One person is needed for assembly/disassembly of the tailplanes.  All parts needed for assembly are delivered together with the aircraft.  Do not push hardly on any surface during manipulation to avoid cracks in the gel-coat (especially in the area of dividing lines, edges, non-reinforced areas).
  • Page 2  Remove the cover of the mounting hole situated under the HT on the left side of the fuselage: mounting hole pin in the steering lever  Connect the right half of the HT with the elevator first. Insert its crossbeam into the hole in the fuselage and insert the elevator into the pins in the steering lever at the same time: ...
  • Page 3 trim servo wire  Install two M8 screws, which connect both halves of the HT, into appropriate holes and screw them into the bulkhead inside the tail. The screws must be secured by the Loctite 243, fitted with a locking washer to avoid their self-loosening and must be properly tightened: 3 of 15...
  • Page 4 M8 screw M8 screws 4 of 15...
  • Page 5  Install M4x35 screw in the hole situated in the front root area of each half of the HT stabilizer. These fix both HT halves with connecting tube. Secure the screws by the Loctite 243:  Prepare two nuts and two washers for M6 screws. Install them on M6 screw fixing the elevator to the steering lever.
  • Page 6 Vertical tail rudder installation  Prepare the VT rudder for its installation to the fin tail: lower carrier upper pin  Push the pedals to deflect the VT rudder either to the left or right. Keeping deflected position, insert the VT rudder (its upper pin) into its upper hinge on the tail fin and push its lower carrier to the tail fin at the same time: upper hinge 6 of 15...
  • Page 7  Prepare two M5x35 stainless screws. Adjust the steering back to neutral position and install both screws on each side of the VT rudder. These fix the VT rudder in the lower carrier:  Install the cover of the mounting hole situated below the left horizontal tailplane: ...

Table of Contents