Advertisement
Treatment Frequency Settings
Your ReBuilder® has three separate therapies it can perform.
light next to "ReBuilder®" will not immediately begin to flash.
After approximately 6 seconds, the light next to "ReBuilder®"
should flicker rapidly for about 6 seconds, then go off again.
This light should repeat the 6 second on and 6 second off cycle
continuously.
To return to the main setting for your therapy of 7.83Hz, press the
frequency button once again. It is important to understand the
frequency button operation in case the setting accidentally gets
changed from the primary setting of 7.83Hz.
R
B
2407 i
e
uildeR
M
nstRuction
anual
7.83 HZ | The primary one for
y o u r s y m p t o m s . W h e n t h i s
first setting is selec ted, the
7.8 3 Hz l i g ht w i l l re ma i n l i t ,
while the light next to the word
"ReBuilder®" will flash rapidly.
E.M.S. | E.M.S. - This signal is
a muscle exercise. To switch
therapies to E.M.S., press the
square frequency button once.
The second light should come
on and remain steady, and the
TENS | Used for spot pain relief
after injury or surgery, but is not
the primary setting to be used for
your symptoms. The TENS light
will light up, and the "ReBuilder®"
light will light up almost steady.
6
Advertisement
