Advertisement
Technical data
General data
Environmental
conditions
Function
Building Technologies Division
Safety class
Degree of protection
Mounting position
Weight
Cable connection
Cable with ferrules
Detector cable
Cable type
Storage
Climatic conditions
Mechanical conditions
Temperature range
Humidity
Transport
Climatic conditions
Mechanical conditions
Temperature range
Humidity
Operation
Climatic conditions
Mechanical conditions
Temperature range
Humidity
Installation altitude
Warning!
Condensation, formation of ice and ingress of water are not permitted!
If not observed, the safety functions are no longer ensured and there will be a
risk of electric shock!
With this type of flame supervision, the radiation of oil flames in the visible band of the
light spectrum is used for generating the flame signal. The light-sensitive element is a
photocell. When illuminated, it generates DC voltage, causing a current to flow to the
input of the flame signal amplifier. Hence, the RAR... is an active detector. The photo-
cell is insensitive to infrared radiation so that glowing firebrick in the combustion cham-
ber cannot produce a flame signal.
II
IP20
Note!
IP40 to DIN EN 60529, at relative
design of cable entry (e.g. AGG09)
optional
approx. 85 g
Screw terminals for min. 0.5 mm² and max.
1,5 mm² wire cross section
Adapt at stranded wire cross section
Supplied by customer
Recommended: H05VV-F 2 x 0.75
Application standards should be observed.
DIN EN 60 721-3-1
class 1K3
class 1M2
-20...+60 °C
< 95 % r.F.
DIN EN 60 721-3-2
class 2K2
class 2M2
-20...+60 °C
< 95 % r.h.
DIN EN 60 721-3-3
class 3K5
class 3M2
-20...+60 °C
< 95 % r.h.
Max. 2,000 m above sea level
5/6
CC1N7713en
15.06.2016
Advertisement
