Advertisement
and CONNECT again or software will crash at next operation.
If a software crash happens turn power off (disconnect USB cable and/or PSU jack). Open software
again, scan for device, select the serial port, click DISCONNECT and CONNECT again.
REMOTE/GATE
Dual input which can be used with external footswitch or gate control voltage.
You can use either a TS jack for using only one remote/gate or a TRS jack for 2 remotes/gate.
These inputs are non-latching, meaning that if you connect a momentary switch, the parameter it is
assigned to will only act in a momentary way (example: turn on only when keep pushed).
These controls are triggered when a connection to ground is detected or on a low logic (0 volt)
signal GATE. Reverse function on V-Uno software can be used to invert the logic.
Inputs are protected against overvoltage and polarity inversion.
These controls can be assigned to any effect parameter via software.
BYPASS
True-bypass switch. The bypass only work on TIP signal. The signal carried by RING is never
bypassed. Pushing the bypass switch will turn on or off the red LED
LED ON = pedal activated
LED OFF = pedal in bypass
SW footswitch
This footswitch can be assigned to any effect parameter via software
I, II and III knobs
These knobs can be assigned to any effect parameter via software
USB and jack DC connectors
USB port is used to upload effects to V-Uno and handle all the dedicated functions. It can be used to
power V-Uno too.
USB can be connected to a PC, either a Windows device or Mac, as well an Android device
equipped with USB OTG (check your mobile device manual to make sure it supports USB on-the-
go).
When used with a mobile device with USB OTG, V-Uno will draw current from the device.
You can power V-Uno from any USB power supply, battery pack included.
The DC jack is for 9v DC supply with negative center pin. The jack DC input is protected against
Advertisement
