Advertisement
Using the ReBuilder®
...Standard Treatment Protocol
Connect the lead wire to input jack. Connect 2 adhesive pads to
leadwire. Place one adhesive pad on the ball of each foot. Turn
the ReBuilder® on and slowly turn up the intensity setting until
you feel a fairly strong tingling sensation and a small amount
of calf muscle activity, then turn the intensity down slightly
until it is gentle enough that you could fall asleep. Use twice
per day for 30 minutes with a minimum of 6-8 hours between
treatments.
NOTE: At higher intensity, you may feel pulsations in your calf
muscle. This is normal. If this results in sore or tired legs, refer
to the troubleshooting guide for assistance.
...Gentle Start Treatment Protocol
Turn the ReBuilder ® unit on just
until it "clicks" on to the number
"1" intensit y setting. Continue
increasing the intensity until you
can just barely notice the impulses.
Use this setting for the first 2 or 3
days to let your nerves acclimate
to the treatment. After the first few
days, gently increase the intensity to the level where you can
feel the impulses but the intensity is still at a level where you
could fall asleep during the treatment. Treat yourself twice per
day with 6-8 hours between treatments. As your body adjusts,
adapts, and improves, the sensitivity level may change and that
is perfectly normal. Your ReBuilder® is working even at very low
settings.
INTENSITY 1
3
Advertisement
