Table of Contents
Advertisement
Quick Links
!!STOP!!
Before proceeding make sure the upper door is the correct item for the vehicle you are installing it on.
DO NOT INSTALL THIS ITEM ON ANY VEHICLE OTHER THAN ONE LISTED ABOVE
The material may have contracted, depending on at what temperature it has been stored. It is highly recommended that you remove the
upper doors from the box; lay it out flat at a temperature above 72F and let it relax for at least 24 hours. As well the installation should be
done only in an environment where the air temp is above 72F.
To avoid improper installation of this item it is imperative that you read and follow these guidelines completely. Failure to install the upper
door skins correctly may result in a dangerous situation for the vehicle occupants as well as other motorists.
SIERRA OFFROAD TAKES NO RESPONSIBILITY FOR THE ACCURACY OR COMPLETENESS OF THESE
INSTALLATION GUIDELINES. THEY ARE PROVIDED ONLY FOR INFORMATION PURPOSES. IT IS
THE SOLE RESPONSIBILITY OF THE INSTALLER TO ENSURE THAT THE INSTALLTION HAS BEEN
PERFORMED CORRECTLY, THERE ARE NO LOOSE OR MISSING PARTS AND THE VEHICLE HAS BEEN
ROAD TESTED AFTER INSTALLATION OF THE REPLACEMENT TOP AND DEEMED SAFE TO OPERATE.
PARTS LIST
Fabric Sun Top
TOOLS REQUIRED
None
THESE UPPER DOORS ARE INTENDED TO BE FIT OVER THE FACTORY ORIGINAL HARDWARE AND FRAME. IF THE FRAME
IS DAMAGED OR MISSING PARTS DO NOT ATTEMPT THIS INSTALLATION BEFORE REPAIRS ARE MADE TO THE VEHICLE.
It is important to read the complete instruction guideline manual BEFORE beginning the installation of your new replacement upper doors.
This will familiarize you with all aspects of the installation and help to avoid mistakes. It will be helpful if you keep this guideline manual for
future reference.
Jeep Wrangler YJ SUN TOP
Installation Guidelines
For:
1988-1995 Jeep Wrangler YJ Sun Tops
PN:
10-40-YJS
Qty 1
FACTORY REPLACEMENT JEEP SOFT TOPS
SIERRA OFFROAD
Advertisement
Table of Contents
Related Manuals for SIERRA OFFROAD 10-40-YJS
Summary of Contents for SIERRA OFFROAD 10-40-YJS
- Page 1 SIERRA OFFROAD TAKES NO RESPONSIBILITY FOR THE ACCURACY OR COMPLETENESS OF THESE INSTALLATION GUIDELINES. THEY ARE PROVIDED ONLY FOR INFORMATION PURPOSES. IT IS...
- Page 2 Wrangler must have the factory OE style Soft Top windshield channel to install Sun Top Check Your Windshield Channel Position the Sun Top over the roll bars and insert the front edge plastic retainer into the Windshield channel. Position Top Roll Bars Sierra Offroad...
- Page 3 1988-1995 Jeep Wrangler YJ SUN TOP Installation Stretch back the rear edge of the Sun Top over and down the roll bar. Stretch Rear Edge Over Roll Bar Insert the rear center strap end through the windshields support bracket. Insert Rear Center Strap Revision a.1...
- Page 4 Guide Rear Center Strap Through Buckle Stretch the rear corners of the Sun Top over and down the roll bar, run the corner straps through the side loops (going forward). Stretch Rear Corners Over Roll Bar Sierra Offroad...
- Page 5 1988-1995 Jeep Wrangler YJ SUN TOP Installation Run the rear corner straps back through the rear corner loops and secure to the male buckles. Secure Rear Corner Straps Secure the buckles into each other and pull straps to secure in position. Secure Buckles Into Each Other Revision a.1...
- Page 6 Locate the side Velcro straps, wrap the straps around the roll bars and fasten. Wrap Straps Around Roll Bars CARE AND MAINTENANCE OF YOUR NEW SUN TOP Wash vinyl fabric exterior only using a mild soap and a soft brush. Rinse thoroughly. Sierra Offroad...
Need help?
Do you have a question about the 10-40-YJS and is the answer not in the manual?
Questions and answers