Table of Contents
Advertisement
In addition to the four stations already set, up to three
more stations may be preset on each band by pressing
two adjoining buttons at the same time. Just:
1. Tune in the desired station.
2. Press SET. (SET will appear on the display.)
3. Press two adjoining buttons at the same time, within
Setting the Tone
BASS:
Slide this lever up or down to increase or
decrease bass.
TREB:
Slide this lever up or down to increase or
decrease treble. If a station is weak or noisy, you may
want to decrease the treble.
five seconds. Whenever you press the same two
buttons, the station you set will return.
Adjusting the Speakers
BAL: Turn the control behind the upper knob to move
4. Repeat the steps for each pair of pushbuttons.
the sound to the left or right speakers. The middle
PSCAN:
Press both SEEK buttons to scan through each
position bahnces the sound between the speakers.
of your preset stations. The system will scan through
for a few seconds. Press either SEEK button or
RECALL to stop scanning through the preset stations.
FADE:
Turn the control behind the lower knob to move
position balances the sound between the speakers.
and play each preset station stored
On
your pushbuttons
the sound to the front or rear speakers. The middle
3-12
Advertisement
Table of Contents
