Table of Contents
Advertisement
CLICK 516 • USER GUIDE
8
PWR (red) lights up when the device has power.
˽
˽
TD (green) lights up when the device is transmitting data.
˽
RD (yellow) lights up when the device is receiving data.
If the Click 516 receives data via one port, it will forward (transmit) the data to other con-
nected ports. However, only the RD (yellow) light will flicker in this case. The TD (green)
light is reserved for data originating from the Click 516.
Located on the front of the module below the DB-9 connector is a push-button labeled
Mode Switch. The push-button allows you to make selections from the menu. (see the Op-
erating Modes section of this chapter for more information).
Hardware Installation
Make sure that the Click 516 is installed on a T-bus with active power and RS-485 com-
munication.
If you are going to use your Click 516 in conjunction with a computer serial port, the RS-
232 DB-9 port on the front of the device can be used to make a connection between the
Click 516 and the computer.
Software Installation
To use Click Supervisor to configure and operate the Click 516 application, you will need to
install the program on your machine.
Yellow LEDs
Red LEDs
Multicolored LEDs
Figure 3 – Click 516 LEDs
Sub Menu 1
Sub Menu 2
Main Menu
Push-button
Advertisement
Table of Contents
