Operating Modes - Wavetronix Click 516 User Manual

Note
To download the current version of Click Supervisor, select a Click 500 series product
from the support section of the Wavetronix website (www.wavetronix.com/sup-
port).
You will also need to manually copy the driver files into a "516" folder in the Program Files\
Wavetronix\ClickHome\Drivers directory on your computer. You can find the driver files
in the compressed folder "516.zip. "
These driver files include:
˽ C516.01.11.09.29.zip
˽ C516.01.11.09.29.txt
˽ Expert.myxaml
˽ Simple.myxaml
Warning
Make sure that the driver files are NOT read-only, otherwise the uploading of the
communication file may not complete properly.

Operating Modes

The Click 516 has two operating modes: Run mode and Device Setup mode. These modes
are accessed through the mode menu, which is controlled via the push-button; the system
(multicolored) LEDs light up to show which mode you are currently on. Table 1.1 shows the
LED color and state associated with each operating mode or task.
Operating Mode/Task
Run
Serial Convertor
Reset
Table 1 – LED States for Operating Modes
The LED state during the mode selection process can be either flashing or solid. If the cur-
rent mode is a flashing mode, the corresponding LED will flash during mode selection.
However, after a flashing mode is selected, the selected mode LED will not flash—the red
LED will flash instead.
Selection LED State
Blue
Green
Red flashing
CLICK 516 • USER GUIDE
Operating LED State
Blue Solid / Red
Green Solid / Red
-
9