Installing A Memory Module - Sony PCV-RX750 System Reference Manual

34
VAIO Digital Studio System Reference Manual

Installing a Memory Module

!
Before opening the system unit, save and close all open files, exit all open
applications, turn off the power to all attached peripheral devices, shut
down the computer, and unplug the power cord.
1
Choose the size of the memory module and configuration as shown
in the following table. Memory modules can vary in size between
sockets. The minimum memory size is 128 MB. The maximum
memory size is 1.5 GB. The BIOS automatically detects the type, size
and speed of the memory modules.
Memory module configurations (MB)
DIMM1
128, 256, 512
* Your computer ships with at least 256 MB. DDR-SDRAM is expandable to 1.5 GB. Your model
may ship with more than 256 MB DDR-SDRAM depending on the configuration you purchased.
✍
Use only PC2100 memory. Your system does not support EDO, buffered DDR-
SDRAM, or PC100/133 SDRAM memory.
2
If necessary, remove the memory module you wish to replace (see
"Removing a Slot Cover"
!
Touch any exposed metal part of the chassis to discharge static
electricity in your body before handling a memory module.
3
Remove the new memory module(s) from its anti-static package.
Hold the memory module only by its edges to prevent static-
electricity damage.
4
Remove the side panel (see
5
Remove the power supply (see
page 44).
6
Remove the screw that secures the AGP add-in card to the chassis.
7
Press down on the handle at the edge of the AGP slot.
DIMM2
128, 256, 512
on page 37).
"Removing the Side Panel"
"Removing the Power Supply"
*
DIMM3
128, 256, 512
on page 24).
on