VAIO Digital Studio System Reference Manual
Declaration of Conformity
This phone number is for FCC-related matters
This device complies with Part 15 of the FCC
rules. Operation is subject to the following two
(1) This device may not cause harmful
(2) this device must accept any interference
received, including interference that may cause
Model No.: PCVA-IMB4A
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
(2) this device must accept any interference received,
including interference that may cause undesired
Sony Electronics Inc.
680 Kinderkamack Rd
Oradell, NJ 07649
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and the receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/
TV technician for help.
You are cautioned that any changes or modifications
not expressly approved in this manual could void
your authority to operate this equipment.
Only peripherals (computer input/output devices,
terminals, printers, etc.) that comply with FCC Class
B limits may be attached to this computer product.
Operation with noncompliant peripherals is likely to
result in interference to radio and television
All cables used to connect peripherals must be
shielded and grounded. Operation with cables,
connected to peripherals, that are not shielded and
grounded, may result in interference to radio and