Pre-Checks - Project Fire Zonecheck Retrofit ZC450-R50 Instruction Booklet

Pre-checks

Before you install Zonecheck follow these simple steps.
1 Open the box and remove all packaging.
2 Check you have the correct sized mech tees.
3 Check that there is a key-switch and key in the box.
4 Please note that this version comes with a pair of Wieland connectors which come
attached to the pump (see image below and refer to wiring instructions on page 07)
5 Inspect the product to make sure it hasn't been tampered with. If you have any queries
please contact your supplier.
1
Note: Use a flat screwdriver to disconnect
the Wieland connectors when completing
wiring