Table of Contents
Advertisement
Additional Wiring Guidance
Your Zonecheck will come with male/female connectors which are connected to the pump.
Simply remove the free (female) side of the connector by using a terminal screwdriver (A).
Remove the cover from the connector using a PH1 screwdriver to expose the terminals
(B). Then wire from the key-switch to the connector ensuring that the wiring matches the
symbols on the connector. Finally, press the two connectors together again until they click/
lock together.
A
B
Female Connector
(to be wired to key-switch)
Male Connector
(pre-wired to Zonecheck pump)
8
Advertisement
Table of Contents
