Seat Adjustment; Seat Belt - Doosan DX35Z Operation And Maintenance Manual

SEAT ADJUSTMENT

1. Front/rear adjustment
Pulling up the adjustment lever (1, Figure 38) allows
the seat to be moved forward and backward over a
range of 210 mm (8.27 in).
2. Backrest Adjustment
Lifting up the adjustment lever (2, Figure 38) under the
front of the seat adjusts the seat back to obtain the
desired backrest angle.
3. Suspension Adjustment
The seat is adjusted for the driver's weight with the
seat empty. The adjustment is made by pulling out the
actuator lever (3, Figure 38). To read off the current
seating pull the actuator leave out until there is a slight
resistance, pulling the actuator lever out of the end
stop will return the setting to 50 kg.

SEAT BELT

Seat belt is for operator's safety and should always
be worn. Before driving machine, adjust seat to
desired position for maximum comfort and machine
control, then fasten seat belt. Seat belts must be
worn across pelvic region and adjusted snugly to
lessen chance and severity of injury in event of an
accident. Never fasten a seat belt across abdomen.
Under no circumstance should operator be standing
in cabin when operating wheel loader.
Do not adjust seat position while vehicle is moving
because a loss
machine, apply parking brake, and then adjust seat.
Always, check condition of seat belt and belt
bracket before fastening it. Do not use it with
twists in it. Replace belt or bracket if damaged or
worn.
Operating Controls
2-24
WARNING!
of control may result.
1 1
2 2
1 1
Figure 36
Stop
2 2
3 3
3 3
BTO0080L
OP000469