Specifications - SBG Navsight Ekinox IMU Hardware Manual

Navsight Solution – Hardware Manual
The default center of measurement is located on top of Horizon enclosure, on the coordinate frame center
drawing. It is represented on the mechanical outlines by the
installation.
Alternatively, user can select between two other center of measurement points:
Alignment hole (aligned to the bottom of the base plate)
●
Bare IMU center of measurement, represented by the
●

2.2.4. Specifications

The table below summarizes all mechanical and environmental specifications.
Electrical and Mechanical Specifications
Enclosure materials
Dimensions
Weight
Input power voltage
Power consumption
Environmental specifications
Altitude rating
IP rating
Humidity
Operating Temperature
range
Storage Temperature range
Shocks
Operating Vibrations
Calibration interval
Anodized Aluminum (6061)
15 x 16.8 x 21.5 cm
4290 g
18 – 32VDC
12W typical
55,000 feet
IP-67
Sealed, no limit
-20 to 60°C – specified range
-40 to 71°C – operating range
-40 to 71°C
6.0g; 20ms half-sine (operational)
40g; 15 ms half-sine (non operational)
4.1g RMS – DO-160F, Cat. SC
None required, maintenance free
17/74
symbol. This point is defined to simplify
symbol.
NAVSIGHTHM.1.3