Care And Maintenance - Westinghouse WKCM504 Instructions Manual

Brewing coffee
1. Fill up the water tank, connect the machine to an electric socket and turn on
the AC mains, the (on/off) button lights up.
2. About 45 seconds later, all 3 buttons will light up, meaning the machine is
ready to brew coffee.
3. Lift the lever.
4. Select the suitable capsule adaptor that matches the desired capsule.
5. Place ground coffee, capsules into the slot inside the capsule adaptor.
6. Insert the adaptor into the machine and put down the lever.
7. Put a coffee cup below the spout to hold liquid coffee.
8. Select a large or small cup according to the desired consumption amount
(press the corresponding button).
9. The selected button will blink and the machine will start brewing. Dispensing
will stop automatically when the default brewing time (+/-25 sec. for small
cup,+/-47 sec. for big cup) is reached. Default setting can be programmed,
please refer to "Coffee Volume Setting" instruction.
10. Raise the lever and pull out the adaptor and dispose the used capsule.
Coffee Volume Setting
Depending on user preference, adjust the desired volume by pressing the small
cup button or large cup button . After warming up the machine, it is ready to make
coffee (on/off button, small cup button, large cup button, all light up.
• Press Small cup button for setting the quantity: keep pressing the small cup
button (minimum 10 seconds, maximum 90 seconds) according to the desired
volume. Release the button, the machine will remember and apply the same
setting on the next occasion;
• Press Large cup button for setting the quantity: keep pressing the large cup
button (minimum 10 seconds, maximum 90 seconds) according to the desired
volume, Release the button, the machine will remember and apply the same
setting on the next occasion.
Stand-by Mode
n factory default standby mode, the machine will be turn off after 15 minutes, and
I
all indicator lights will be off.
• Press the On/Off Button to switch on the machine again if the machine is in
standby mode.
SETTING THE STANDBY MODE
Keep pressing the small cup button and large cup button at the same time, insert
the plug to the socket.
• On/Off button light will be on.
• Press small cup button, small cup button light off, standby mode cancelled.
• Press small cup button, small cup button light on, standby mode activated.
Resetting to Factory Default setting
• Press the big cup button, insert the plug to the socket.
• The indicator light of buttons will flash twice. It means the machine come back
to factory default setting.

CARE AND MAINTENANCE

WARNING:
• Switch off and unplug the coffee maker before cleaning and performing
maintenance.
• The used coffee adaptor is used in high temperatures so be careful of burns.
EN
• Do not immerse the device in water.
• Prohibited splashing water to the machine.
8
Untitled-1 8 22/8/2019 18:24:12