UNILITE ANSI FL 1 Standard Quick Start Manual

FEATURES
• High power 275 Lumen white CREE LED
• Hard anodized die cast matte aluminium body
• 2 x AAA Duracell Alkaline Batteries (included)
• Tactical rubberised micro switch
• 2 Light mode settings
• Flawless smooth reflector for long distance beam
• Pocket clip attachment
• Dust and waterproof IP66
• Impact resistant to 1m
BATTERY - 2 x AAA 1.5v Duracell Alkaline Batteries [Inc]
WEIGHT - 65g [with batteries] 41g [without batteries]
DIMENSIONS - Ø18mm x 137mm
ADVICE & IMPORTANT INFORMATION!
Only use high-quality Alkaline batteries or Ni-MH rechargeable batteries. DO NOT
USE rechargeable LITHIUM batteries, these will damage your flashlight as they
exceed rated voltage.
Do not use batteries of different brands or mix old and new batteries. Please
recycle used batteries responsibly.
Battery life is affected by different battery brands, different ambient temperatures
and different lighting modes.
If the battery is installed and the flashlight does not work, try checking for the
following: (1) Press the switch button several times. (2) Check that the batteries are
inserted the correct way around according to polarity markings. (3) Check there is
no debris on the contacts that might affect the battery connection. (4) Check there
is no water or dampness in the flashlight, if so, allow it to fully dry out and try again.
Do not look directly at the LED.
Do not operate in direct sunlight or extreme temperature conditions (below -10°C
or above 40°C).
The LED will become hot when switched on; do not touch and do not place face
down on any surface – risk of fire!
Do not use the device if there is any visible damage to the housing, switch or lens.
Children under 12 years of age should only use the product under adult
supervision.
Do not open, disassemble or attempt to modify the product; this will void the
warranty and can be dangerous. Improper use or modification is not covered
www.unilite.co.uk
ANSI F L 1 Standard
HIGH
LOW
OPERATION
SWITCH Sequence: High > Off > Low > Off
PT-2
under the warranty.
Take care not to let the lenses come into contact with hard/sharp objects, damage/
scratches to the lenses will affect light output.
If you are not using the product for long periods of time (3 weeks or more), remove
batteries to prevent battery leakage and battery depletion. Battery leaks are not
covered under warranty.
Protect batteries from heat, intense sunlight, fire, water and moisture – danger of
explosion!
If batteries are damaged, fluids can leak out. AVOID contact as this can lead to
skin irritation and/or burns. If skin contact happens, rinse thoroughly with water. If
irritation persists, seek medical advice.
Seek immediate medical assistance if battery fluid comes into contact with the
eyes.
This product has a 1 year standard warranty (or extended 2 years once registered
online at WWW.UNILITE.CO.UK/WARRANTY) against manufacturing faults and
defects. It does not cover normal wear and tear, modifications, accidental damage
or poor maintenance. Unilite warranties do not cover battery leaks or the use of
incorrect chargers and cables that can damage rechargeable batteries.
Do not dispose of this device in normal household waste. It must be disposed of
via an authorised disposal centre or at your local waste disposal unit.
Please recycle or re-use packaging where possible.
Keep these instructions for future reference or for subsequent possessors.
PT-2
275
90 M
Lumens
40
35 M
Lumens
2 x AAA Alkaline Batteries
NOTE: use a high quality brand
OPEN
ON/OFF Switch
1 H
15 H