Chevrolet 1993 Corvette Owner's Manual page 269

Service
&
Appearance Care
Adding Caalant-LT5
Enghe
(CONT,)
2.
Add the coolant mix to the coolant
high fill reservoir until the level
reaches the base of the res&voir filler
neck
3 . With the pressure cap still removed,
run the
engine until the upper
radiator hose is hot. With the engine
at idle, add coolant m i x again, if
needed, to bring the level back up to
the reservoir filler neck base.
4.
Put on the pressure cap. When it's
tight, the arrows on the cap should
line up with the overflow tube on the
reservoir filler neck.
Coolant
High Fill Reservoir
Pressure Cap
I
When you replace your coolant high fill
reservoir pressure cap, an AC@ cap is
recommended.
Engine coolant temperature is
controlled by a thermostat in the engine
coolant system. The thermostat sfops
the flow of coolant through the radiator
until the .coolant reaches a preset
temperature.
When you replace your thermostat, - a n
AC*
thermostat is recommended.