Reinstalling The Roof Panel - Chevrolet 1993 Corvette Owner's Manual

Reinstalling the Roof Panel:
'1. Follow steps 1-7 in
Removing
the
Roof Panel,
earlier this .section, to
prepare your vehicle.
2. Open the rear hatch and remove the
roof panel horn its stored position by
reversing the procedure in Storing the
Roof Panel, earlier in this section.
3 . Lower the roof panel onto the top of
7. Fully tighten the rear bolts, then the
the vehicle, rear edge first, placing the
front bolts. If the balts- aren't tight
rear guide pins of the roof panel into
enough, the roof panel may male a
their locating holes.
popping noise wbde you drive. If this
4 . Lower the front of the roof panel and
I
happens, tighten the bolts securely.
I
position the front guide pins.
the two rear attaching bslts.
5.
Use the wrench to partially tighten
I
I V U I I t €
I
6.
Use the wrench
to loosely start the
front two attaching bolts, making
sure the bolts are properly threaded
into the roof panel. I f the front bolts
seem hard to start, tighten the rear
bolts some more. Also, holding down
the panel on the outside will help you
start the bolts.