Advertisement
PARALLEL CONFIGURATION
ANODE
PACK 4
1.
Ensure all batteries to be in the parallel configuration have been fully charged
individually by matched chargers.
2.
Ensure OCV of each battery is less than <0.2V of each other.
3.
After charging, set aside and allow to rest for 8 hours.
4.
Utilising wires of circumference large enough to carry required current (>100A), connect
the batteries in the above (Fig 1) configuration. Ensure all connecting cables lengths are
of the same length.
5.
Be careful not to reverse connect the Positive and Negative.
6.
Ensure correct charge voltage and current is utilised for configuration.
7.
It is absolutely prohibited to series a paralleled configuration.
8.
Once in Parallel configuration ensure a full charge is completed a min of every 3 months.
9.
Once in Parallel configuration, the system must be charged and discharged as a system.
If one battery needs to be replaced, the whole system will require replacing.
FIG 1
CATHODE
PACK 1
Advertisement
