Detaching the Diskette Drive
You need to detach the diskette drive and pull it out approximately two
inches to access the system memory.
1
Remove the two screws that secure the diskette drive carrier to the
chassis.
2
Slide the diskette drive carrier out approximately two inches (enough
to provide access to the memory modules).
Be careful not to hook the plastic LED and power-switch cover when sliding the diskette
drive in or out. The metal tab on the diskette drive may come close to the plastic cover. If
the plastic cover is accidentally removed, reattach it by inserting the plastic tabs into the
slots in the chassis.
3
Unplug the flat ribbon cable and power connector (P4), as needed.
Removing, Installing, and Replacing Components
39
KY0074.VSD
KY0075.VSD