Techinical Data - Yamato SA115/SHORTK Instruction Manual

cod. 52621 - 55260
1. EQUIPMENT
1 pc. Angle grinder YAMATO (without wheel)
1 pc. Handle
1 pc. Flange wrench
1 pc. Instruction Manual

2. TECHINICAL DATA

Model
Code
Rated Voltage (Frequency) :
Protection :
Rated Power :
Filetto perno :
No load speed :
Grinding Wheel Ø :
Net Weight :
vibration: weighted acceleration m/s2. K=1,5 2,62
sound power level dB (A) K=3 dB (A)
Sound pressure level dB(A) K=3 dB (A)
Noise/Vibration Information
Measured values determined according to EN 60745.
Uncertainty K=3 dB.
Wear hearing protection!
The typically weighted acceleration is on the above table.
The vibration emission level given in this information sheet has been measured in accordance with
a standardised test given in EN 60745 and may be used to compare one tool with another. The
vibration emission level will vary because of the ways in which a power tool can be used and may
increase above the level given in this information sheet.
Note: To be accurate, an estimation of the level of exposure to vibration experienced during a
given period of work should also take into account the times when the tool is switched off and
when it is running but not actually doing the job. This may significantly reduce the exposure level
over the total working period.
Intended Use
The machine is intended for roughing and brushing metal and stone materials without using water.
For cutting stone, a cutting guide is required. Don't use for cutting with equipped protection.
When using electric tools it is imperative to take the following basic safety precautions in order to
reduce the risk of electric shock, injury and fire. Read and take note of these instructions before you
use this tool.
3. GENERAL SAFETY REGULATION
• Read this manual carefully before operation to avoid the hazards such as electric shock, burn of
fire.
• The work area must be kept clean to avoid danger.
• Pay attention to the environment, do not expose the tool in rain or humid place. Keep work area
lit up. Don't use the tool in presence of inflammable liquid or gas.
• Pay attention to do not touch the grounding parts, pipes, heat elements, so that to avoid
electric shock.
• Take care of the tool. Put it in dry place when not in use, and far from children.
• Don't overload the tool. Operate only within the load level suggested.
INSTRUCTION MANUAL ENGLISH VERSION
SA115/SHORTK
52621
230 V (50 Hz)
Classe II
850 W
M14
12.000/min.
115 mm
2,05
LpA 86 dB(A) K=3 dB (A)
LwA 97 dB (A) K=3 dB (A) LwA 97 dB (A) K=3 dB (A)
SA125/SHORTK
55260
230 V (50 Hz)
Classe II
850 W
M14
12.000/min.
125 mm
(not included)
2,05
2,62
LpA 86 dB(A) K=3 dB (A)
(not included)