Safety Information - DStv 6S Quick Start Manual

Safety Information

This DStv HD Decoder (6S) meets International Safety Standards. Please read the following recommended
safety precautions carefully.
Mains Supply
The DStv HD Decoder (6S) operates at 12 V DC and is connected to the mains supply using the supplied power
supply, rated 100 - 240 Vac 50/60Hz. Connect the power supply unit to the decoder and the power cable to the
power supply unit, before connecting the other end of the power cable to the mains wall socket. When
disconnecting the power, switch off the power at the wall, and remove the power cable from the wall socket
(rather than removing the power supply from the decoder). We recommend that you install the decoder close
to the wall socket, with the wall socket being easily accessible.
Liquids & Spillage
Keep liquids away from the DStv HD Decoder and do not put anything on top of it which may spill (example: lit
candles, plants or containers of liquid). Do not use the DStv HD Decoder in extreme temperature and humid
conditions.
Ventilation
It is essential to keep the DStv HD Decoder cool to prolong the life of the hard disk. Do not block the ventilation
ventilation of the decoder, ensure that there is at least 10cm of free space above and to the sides of the DStv
HD Decoder. Never stand the DStv HD Decoder on soft furnishings or on carpet. Do not use, or store the DStv
HD Decoder near a heater or where it is exposed to direct sunlight. Never stack other electronic equipment on
top of, or below the DStv HD Decoder.
Cleaning
15
DStv HD Decoder Quick Start Guide