Johnson Controls IQ Dimmer User Manual page 2

ADVANCED CONFIGURATION
Configurable Parameter Se�ngs: If your controller supports Z-Wave configurable
parameters, the following se�ngs can be modified.
Parameters
# Descrip�on
LED Mode Indicator When value = 0, the LED indicator will be
3
OFF when the connected appliance is
ON, and the LED indicator will be ON
when the connected appliance is OFF.
If value = 1, the LED indicator will be OFF
when the connected appliance is OFF,
and the LED indicator will be ON when
the connected appliance is ON.
If value = 2, the LED indicator will be
always OFF regardless of the load status.
Set dimmer ramp Valid Values: 0-99,
11
rate (remote) 0=No delay (instant ON), 1=1 second
Set dimmer ramp Valid Values: 0-99,
12
rate (local) 0=No delay (instant ON), 1=1 second
Depending on the capability of your controller or gateway so�ware, the following
simple to advanced opera�ons can be performed. Please refer to the controller's or
gateway manual for details.
Associa�ons:
IQ Dimmer supports Group 1 for lifeline communica�on and Group 2
- You can associate five Z-Wave devices to Group 1.
- Lifeline associa�on only supports the "manual reset" event.
- For instruc�ons on how to "set lifeline associate", please refer to your controller/
gateway instruc�ons.
- You can associate five Z-Wave devices to Group 2.
- The devices in Associa�on Group 2 can be controlled (on/off/dim) by single
pressing the bu�on using Basic Set
SPECIFICATIONS
Model PD700
Input power 120 VAC, 60 Hz.
Max output loading 2.5A, 300W Incandescent, 65W Dimmable CFL/LED
Radio frequency 908.4/916 MHz.
Wireless range 279� Outdoor line of sight
Normal opera�ng
32°F - 104°F (0°C - 40°C)
temperature
FOR INDOOR USE ONLY
Interoperability with Z-Wave devices
A Z-Wave network can integrate devices from various classes of products, and
these devices can be made by different manufacturers. The product introduced in
this instruc�ons manual has a Z-Wave cer�fica�on which allows such an
interoperability.
SUPPORTED COMMAND CLASSES
Descrip�on
COMMAND_CLASS_ZWAVEPLUS_INFO
COMMAND_CLASS_SWITCH_MULTILEVEL
COMMAND_CLASS_ASSOCIATION
COMMAND_CLASS_MULTI_CHANNEL_ASSOCIATION
COMMAND_CLASS_ASSOCIATION_GRP_INFO
COMMAND_CLASS_TRANSPORT_SERVICE_
COMMAND_CLASS_VERSION
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_DEVICE_RESET_LOCALLY
COMMAND_CLASS_INDICATOR
COMMAND_CLASS_POWERLEVEL
COMMAND_CLASS_CONFIGURATION
COMMAND_CLASS_SECURITY_2
COMMAND_CLASS_SUPERVISION
COMMAND_CLASS_APPLICATION_STATUS
COMMAND_CLASS_FIRMWARE_UPDATE_MD_V5
Values Default Bytes
0
3
3
Version Security Class
v2
v4 S2
v2 S2
v3 S2
v3 S2
v2
v3 S2
v2 S2
v1 S2
v3 S2
v1 S2
v4 S2
v1
v1
v1
v5 S2
FCC ID: 2AMY9PD700
Supplier's Declara�on of Conformity
47 CFR 2.1077 Compliance Informa�on
Model: PD700
Responsible Party – US Contact Informa�on
Qolsys, Inc.
1
1900 The Alameda Suite 420
San Jose, CA 95126
United States
intrusion-support@tycoint.com
FCC Compliance Statement (Products subject to Part 15)
This device complies with part 15 of the FCC rules. Opera�on is subject to the
following two condi�ons: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired opera�on.
1
NOTE: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifica�ons or changes to this equipment. Such modifica�ons or
1
changes could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protec�on against harmful interference in a residen�al
installa�on. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruc�ons, may cause harmful
interference to radio communica�ons. However, there is no guarantee that
interference will not occur in a par�cular installa�on. If this equipment does cause
harmful interference to radio or television recep�on, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separa�on between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
IC: 22968-PD700
This device complies with Part 15 of the FCC Rules and with RSS of Industry
Canada. Opera�on is subject to the following two condi�ons:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired opera�on.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploita�on est autorisée aux deux condi�ons
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'u�lisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est suscep�ble d'en comprome�re le fonc�onnement.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
Z-Wave is a registered trademark of Silicon Labs.
WARRANTY
Qolsys warrants to the original purchaser of this product that for the warranty
period, this product will be free from material defects in materials and workmanship.
The foregoing warranty is subject to the proper installa�on, opera�on and
maintenance of the product in accordance with installa�on instruc�ons and the
opera�ng manual supplied to customer.
Warranty claims must be made by customer in wri�ng within 30 days of the
manifesta�on of a problem. Qolsys' sole obliga�on under the foregoing warranty is
to repair, replace or correct any such defect that was present at the �me of delivery
or during the warranty period. The warranty does not extend to consequen�al or
incidental damage to other products that may be used with this product. For inquiry
and customer service, emailintrusion-support@tycoint.com.
All brand names shown are trademarks of their respec�ve owners.
Warranty period: limited 1 year from date of purchase.