Cadillac 2001 Catera Owner's Manual page 105

Turn and Lane Change Signals
To signal a turn, move the turn signal/multifunction
lever all the way up or down. The lever returns
automatically when the turn is complete.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns when it is released.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned
bulb. (This does not occur with a burned
Other drivers won't see the turn signal. Replace
-
burned out bulbs to help avoid possible accidents.
Check the fuse (see "Fuses and Circuit Breakers" in the
-
Index) and for burned out bulbs if the arrow fails to
work when signaling a turn.
2-38
This arrow on the
instrument panel cluster
will flash in the direction of
the turn or lane change.
-
out front signal
-
out rear bulb).
Headlamp High/Low Beam
With the Twilight Sentinel
control dial turned to the headlamp position, push the
turn signal/multifunction lever on the driver's side of
the steering wheel away from you to turn on the
-
high beam headlamps.
Pull the lever back to the original position to return to
-
low beam headlamps. For more information, see
"Headlamps" in the Index.
Flash-To-Pass
This feature uses the high
driver in front of you that you want to pass. This feature
will work with either the headlamps on or off.
To use, pull the turn signal lever toward you and release.
R
on or with the lamp
This light on the instrument
panel cluster will be on,
-
indicating high beam usage.
-
beam headlamps to signal the