Table of Contents
Advertisement
To reinstall the filler panel:
1. Place the filler panel in the correct location.
-
2. Reset each push
pin by holding each by the outer
circle while pushing up on the pin assembly from
below. The center portion of the push
now be above the outer circle.
3. After placing each push
down on the outer circle until it is seated against the
surface of the filler panel.
-
4. Lock each push
pin in place by pressing the center
of each down until they are level with the outer
circles. Use care not to press down so far that the
-
push
pin releases again.
6-38
-
pin should
-
pin into the opening, press
Headlamp Aiming
Your vehicle has a visual optical headlamp aiming
system equipped with horizontal aim indicators. The
-
aim has been pre
set at the factory and should need
no further adjustment. This is true even though your
horizontal aim indicators may not fall exactly on
the "0" (zero) marks on their scales.
Advertisement
Chapters
Table of Contents
