Troubleshooting - RedMax CZTE54 Operator's Manual

Always use good quality grease. Always use
recommended oil, refer to
29 .
To lubricate the front wheels
• Grease the nipple (A) with a grease gun until
grease comes out from the top washer.
A
• Lubricate the joint bearing of the front wheels (B)
with a grease gun until grease comes out.
Tightening torques
Engine crankshaft bolt
Deck pulley bolts
Lug nuts
Blade bolts
Spark plug
Troubleshooting schedule
If you cannot find a solution to your problems in this
operator's manual, speak to your RedMax service
agent.
Problem
Engine does not start.
1718 - 001 - 23.08.2021
Technical data on page
B

Troubleshooting

Cause
The drive of the blades is engaged. Refer to
Off) button on page 5 .
Steering controls are not locked in the neutral.
The battery is too weak. Refer to
18 .
There is dirt in the carburetor or fuel line.
The shut-off valve of fuel supply is closed or in incorrect posi-
tion.
The fuel filter or fuel line is clogged.
The ignition system is damaged.
To lubricate the cutting deck
spindles
1. Set the cutting deck in mow position.
2. Lubricate each cutting deck spindle 2-3 strokes.
Note:
Use a grease gun with a rubber hose
when you lubricate the cutting deck spindles.
68 Nm / 50 lb ft
204 Nm / 150 lb ft
102 Nm / 75 lb ft
122 Nm / 90 lb ft
22 Nm / 16 lb ft
To charge the battery on page
PTO (Power Take-
25