Sony Bravia KDL-19M4000 Operating Instructions Manual page 17

2
Secure the TV to the Stand.
Use the optional hardware listed below (not supplied):
• M6 × 12-18mm anchor bolt (screwed into the TV's stand).
• A screw or similar (attach it to the TV stand).
• Rope or chain (strong enough to support the weight of the TV). Make
sure that there is no excess slack in the rope or chain.
An alternative way to secure the TV is with an optional Sony Support
Belt Kit.
Contact Sony Customer Support to obtain the optional Support Belt Kit
by providing your TV model name.
- For United States call: 1(800)488-7669
or visit: www.sony.com/accessories
- For Canada call: 1-877-899-7669
3
Anchor the TV to the Wall.
Use the hardware listed below (not supplied).
• Two M4 × 12-18mm anchor bolts (screw into the top-most wall-
mount holes located on the rear of the TV).
• Rope or chain (attach to one M4 anchor bolt).
• Wall-anchor (attach to the wall stud) strong enough to support the
weight of the TV (pass the rope through the wall-anchor, then attach
to the other M4 anchor bolt).
Anchor
bolts
Measure 2 provides minimal protection against the TV toppling over.
For further protection, follow all three measures recommended above.
If an electric screwdriver is used, set the torque to tighten at
approximately 1.5 N·m {15 kgf·cm}.
Anchor
bolt
Screw hole on the TV's stand
Wall-mount
holes
Rope or
chain
Getting Started
Screw
Wall-
anchor
17