SECO-LARM ENFORCER SM-207-5Q/W Manual

3
/ " Concealed-Mount
8
Contacts, Stubby
SM-207-5Q/W / SM-207-5Q/BR
Manual

Specifications

Model
Loop Type
Electrical
configuration
Operation gap
Connectors
Color
Case
Material
Contacts
Contact rating
Operating
temperature
Switch cycles
Switch
Dimensions
Magnet
Magnet

Installation Notes

Contact and magnet must be installed on the protected side of
the door/window.
California Proposition 65 Warning: These products may contain chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more
information, go to www.P65Warnings.ca.gov.
LIFETIME LIMITED WARRANTY:
obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be responsible for any
costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration,
improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material
and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM's option. In no event shall SECO-LARM
be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited warranty is for products sold and installed
in the United States and Canada. For all other countries the warranty is 1 (one) year.
NOTICE: The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not
responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2021 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800
SM-207-5Q/W
Closed loop
N.O. (SPST)
/ " (10mm)
3
8
15" (38cm) Leads
White
High impact ABS plastic/epoxy compound
Deactivated rhodium on gold underplating
1.0A@10VDC (max.)
10W (max.)
-15°~160° F (-25°~70° C)
50 Million (0.1mA@5VDC)
/ "xø / " (19xø11 mm)
3 7
4 16
/ "xø / " (19xø11 mm)
3 7
4 16
Alnico 5
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product. SECO-LARM's
®
U.S.A., Inc.
 Used for protecting sliding doors and windows
where space is limited

3 / " (10mm) Press-fit mount
8
 15" (38cm) Wire leads
 Contact reed switch is SPST, deactivated
rhodium on gold underplating for a longer
expected life
 Unique glue/epoxy compound protects reed
switch
 For closed loop circuits

/ " (10mm) Gap
3
8
 Lifetime limited warranty

Parts List

10x Contact switches
1x Manual

Installation

Please read the manual carefully before
SM-207-5Q/BR
you begin the installation.
1. Mount the contact above the door or
window on the frame. For doors, ensure
that the mounting is farthest from the
hinged side of the door.
2. Connect two wires to the contact
Brown
terminals and to the alarm control panel.
3. Mount the magnet on the door/window
so that it will face the contact. Be sure
that the gap between the contact and
magnet does not exceed
.
Website: www.seco-larm.com
Email: sales@seco-larm.com
10x Magnets
3 / " (10mm).
8
GND
Alarm
Control
N.O.
Panel
Hinged side
of door
®
PITSW1
Order Part# 763-208-1%
MI_SM-207-5Q_210121_ML