Advertisement
Your TV receives signals from the video recorder (VCR) like another TV station.
You have to select a channel number on your TV and tune it in so that you may watch video
tapes.
If you have used a SCART cable then your TV should already have a dedicated video
channel built into it, usually called AV.
POWER
TV/VTR
Make sure that you have
Insert a pre-recorded
correctly installed your
video tape into your VCR
VCR as described earlier
and press PLAY on the
in this book.
remote control.
Press POWER to turn on
your VCR.
Turn on your TV.
Select a TV channel
number on which you
POWER
POWER
POWER
EJECT
EJECT
wish to watch video's.
TV/VCR
TV/VCR
TV/VCR
AV
AV
CM SKIP
CM SKIP
G-CODE
Don't worry if you don't
ez POWER OFF
ez POWER OFF
have a video-tape to play
ez REPEAT
at this stage!
If you switch your VCR
on and continue stages
3 ~ 4, instead of seeing
video playback tune your
TV until you see a bright
blue screen.
G-CODE
C.LOCK
EJECT
AV
CM SKIP
Tune this channel until
ez POWER OFF
the video picture is sharp
ez REPEAT
and the sound is clear.
If you have used a
SCART cable you will
not have to tune your TV,
simply select the AV
channel. The AV channel
is already pre-tuned for
optimum video playback
EJECT
on your TV.
AV
CM SKIP
C.LOCK
ez POWER OFF
ez REPEAT
PROG.
C.LOCK
Store this channel on
your TV.
You will need to look at
the TV instruction book if
you do not know how to
do this.
The output frequency of
this video recorder (VCR)
is set at UHF channel 36.
If channel 36 is already
used by another TV
station, or if the picture is
distorted, you can
change the transmitter
channel of your VCR.
Stages 5 ~ 8 will show
you how to change the
output frequency of your
VCR.
7
Advertisement
