Chg Burner Flame - Burnham CHG CHG225 Installation & Operation Manual

7) Start the boiler using the lighting instructions on page 40. After the boiler is powered up, it should go through
the following sequence.
Sequence Display
1 U.125
2 0.SWT
(After call for heat from heating thermostat)
3 A.SWT
4 5.SWT
5 1.SWT
6 2.SWT
7
3.SWT
8) Upon initial start-up, the gas train will be filled with air. Even if the gas line has been completely purged of air,
it may take several tries for ignition before a flame is established. If more than 5 tries for ignition are needed,
it will be necessary to press the reset button to restart the boiler. Once a flame has been established for the first
time, subsequent calls for burner operation should result in a flame on the first try.
9) Inspect the flame visible through the window. On high fire the flame should be stable and mostly blue
(Fig.10.1). No yellow tipping should be present; however, intermittent flecks of yellow and orange in the flame
are normal.
10) Check the inlet pressure and adjust if necessary. Verify that the inlet pressure is between the upper and lower
limits shown on the rating plate with all gas appliances on and off.
ThE COrrECT OuTlET PrEssurE fOr ThE gas ValVE has bEEN
faCTOry sET aND rEquIrEs NO fIElD aDJusTmENT. ThIs sETTINg Is
saTIsfaCTOry fOr bOTh NaTural gas aND PrOPaNE. aTTEmPTINg TO
aDJusT ThE OuTlET PrEssurE may rEsulT IN DamagE TO ThE gas
VALVE AND CAuSE PRoPERTy DAMAGE, PERSoNAL INjuRy oR LoSS oF
lIfE.
Meaning
or Blank Checking internal software (power-up only)
Boiler in standby.
Self-Check on Start-up
Blower and circulator on. Checking for adequate air flow.
Prepurge
Trial for ignition
Flame established. Boiler responding to a call for heat.
Figure 10.1: CHG Burner Flame
warNINg
SWT = Supply Water Temp. No call for heat.
41