Pride Mobility Quantum TB3 Installation Instruction

If you require any assistance with these instructions, please call Quantum Technical Service at
WARNING! Prior to performing any actions to the power chair, ensure the power is
turned off at the joystick and the power base is in drive mode.
NOTE: Only the right side is shown. The left side installation mirrors the right.
NOTE: The following symbol
millimeters. Example:
Tools Required:
- Metric Hex Key Set
- Calibrated Torque
Wrench
- Measuring Tape
Hardware shown removed for illustration purposes only.
1
8
mm
Mounting Hardware
- Loosen the Mounting Hardware and Hinge
Screws. The Hinge Points should be loose but
remain connected.
Rev A / August 2020
Down Post Installation Instruction
TB3 Version 3 Flip-back Armrest
1-877-800-1248. Canada providers, call 1-888-570-1113.
#
mm
6 is a 6 millimeter Hex Key.
mm
Down Post Assemblies
8-10"H
Hinge
Point
Hinge
8 Point
mm
6
mm
Hinge Screws
will be used to indicate the size of the Hex Key needed in
8
mm
11"-13"H
Reverse
2
6
mm
Back
Forward
Back
- Slide the receiver block into the side rail. The
Reverse orientation is used for 8" - 10" high armrests,
the Forward orientation is used for all other armrest
heights.
1
is an 8mm Hex Key.
14"-16"H
Front
Front
Forward
Orientation
Shown