Advertisement
Connection to the Device
Default IP address 192.168.20.20
• The Ethernet service interface is used for the commissioning of PowerLink CM. It is
located at the front of the DMB (LCT). For the initial connection between the service PC
and the service interface use the default IP address. After entering the IP address
(https://192.168.20.20) in the browser of your service PC you can login to the WEB UI to
configure the service interface for information, monitoring and configuration of PowerLink
CM. For more details as the default role-based users and passwords see the user
manual.
• The corresponding software package (formerly delivered on
DVD) is available for download on SIOS (Siemens Industry
Online Support) platform free of charge, a registration is
required.
Product Support/Energy/Energy automation and smart
grid/Smart communication/Download
• Test protocols are available for download under
https://www.ea-testreports.siemens.com
Enter BF code of device to view the requested test protocol in
pdf format. The installed software package version loaded into
the device can be seen in the protocol.
Switch off the System
• Switch S1 enable/disable Power Supply on DMB located behind the front cover, in down
position.
Units of PowerLink CM
Interfaces/Ports of PowerLink CM
Smart Communications, PowerLink CM Product Information
C53000-X6040-C256-2 Edition Sept. 2021
Technical Data
HF- Interface
Output power
100 W-amplifier, up to +50 dBm PEP
Adjustable 20 W to 100 W
Rated output impedance
75 Ohm unbalanced or 150 Ohm balanced
Spurious emission, Return Loss,
In accordance with IEC 60495
Tapping Loss, Balance to ground,
Receiver sensitivity and Selectivity
Tx Filter
Simple adjustment by jumpers
Rx Filter
The Rx filtering is done in digital domain and is
adjusted automatically.
Power Supply
Input voltage range
PSPA2-DC
DC 38 V to DC 72 V
PSPA2-AC
AC 93 V to AC 264 V (47 Hz to 63 Hz)
DC 85 V to DC 264 V
Power consumption
100 W Amplifier (AC/DC)
typ. value normal operation 358VA/131W
typ. value max operation 559VA/215W
Ethernet Interface
Ethernet
1 x 100BASE-TX Full Duplex
RJ45 service interface (LCT port)
3 x 10BASE-T or 100BASE-TX Half/Full
Duplex/Auto Negotiation; PoE on port 3 : IEEE
802.3af, 15.4 W; RJ45 user interfaces
2 x Ethernet 100BASE-FX; SFP user interfaces
Layer 2 switch
Transparent Layer 2 bridging
Ethernet II, IEEE 802.3, IEEE 802.1Q
IEEE 802.1ad Provider Bridge/Q-in-Q (Carrier
Ethernet)
MPLS labeled Layer 2 VPN frames
Jumbo frame: max. frame size 2000 bytes (without
preamble) on all five user interfaces
Maximum Transmit Unit (MTU) for IPv4 over
Ethernet: 1500 byte on service interface (LCT)
Climatic Conditions
Cold
-10°C
IEC 60068-2-1
Dry heat
+ 55°C
IEC 60068-2-2
Damp heat, cyclic
+ 25°C at 95% humidity
IEC 60068-2-30
+ 55°C at 93% humidity
Mechanical Design
19" frame
Dimensions
482 mm x 266 mm x 300 mm (W x H x D)
Weight
19 kg
Degree of protection
IP20
PowerLink CM
2
Advertisement
