HAMPTON BAY ANSELMO D6051-7PC Manual page 9

Table Assembly
1
Connecting the table legs
Remove the table glass (L) and stone top (M) and set both
□
in a safe place and in a vertical position until the table is
completely assembled.
Turn the table rim (G) upside down and place on a at
□
surface.
Attach the table legs (H) to the table rim (G) by inserting
□
bolts (BB) and washers (EE) through the pre-drilled holes in
the table rim (G) and into the table legs (H).
NOTE: Hand tighten the bolts only. Do not fully tighten.
BB
EE
H
G
2
Connecting the leg connector to
the table legs
Attach the leg connector (J) to the table legs (H) by
□
inserting bolts (BB) with washers (EE) through the pre-
drilled holes in the leg connector (J) and into the table
legs (H).
9
Please contact 1-877-527-0313 for further assistance.
EE
BB
H
J
HAMPTONBAY.COM