Changing Or Erasing The Function Of A "Learned" Button - Sony RM-VL610A Operating Instructions (RM-VL610A Remote Commander®) Operating Instructions Manual

Programming signals of another
remote control — Learning
Function (continued)
Changing or erasing the
function of a "learned"
button
To change the "learned" function,
clear it first and perform Learning
again.
To clear the "learned" function
of a single button
1,3
22
Example: To erase the "learned"
function from the Number
button 1 in VCR mode
1
Press and hold SET for over
3 seconds.
The SET indicator flashes.
2
While holding the desired
Component Select button
pressed, press the button
you want to erase.
When erasing of the "learned"
function is completed, the
2
selected Component Select
button light turns off.
during data
erasing
Note
Be sure to press the button you
want to erase while pressing the
Component Select Button. If you
release the Component Select
button, the Commander changes to
Learning mode.
3
Press SET to finish setting.
To cancel erasing, press SET.
data erasing
complete