2 . INSTALATION OF THE CONTROL PANEL EXTENSION CORD
WARNING
Turn OFF the Main Power Switch of the CONTROLLER before attaching the Control Panel
・
Extension Cord.
When attaching the Control Panel, protect the Control Panel from oil and other contaminants.
・
Take care when selecting routing of cord of Control Panel to insure that the cord is not routed
・
near potential sources of RF noise.
Attach the Control Panel in manner to insure that the back of the circuit board of the Control
・
Panel does not contact any object or surface that could cause potential short circuit.
① Rmove the Mounting Screw (4pcs.) of the Control Panel and remove the Control Panel to front.
② Remove the connector of the Control Panel (Fig. 3) and remove the Control Panel (Fig. 4).
6
Connector
Fig. 3
Fig. 2
Monting Screw
Control Panel
Fig. 4