EMS FC-171-001 Installation Manual

Wireless Beacon
Installation Guide
1 Pre Installation
Installation must conform to applicable local installation
!
codes and should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed
device, as this will cause communication with the Control
Panel to be lost. Should this happen, delete the device from
the system and add it back on.
3 Fix Mounting Plate
Remove the mounting plate from the wireless module by turning
it anticlockwise.
When wall mounting, ensure the mounting plate is fitted in the
orientation shown.
Use both mounting holes.
Use suitable fasteners and fixings.
5 Optional Device Locking
To lock the Beacon into
the wireless module,
remove the cut out section
as shown.
To unlock, insert a 1.5mm
Allen key to depress the
locking clip and turn
anticlockwise to release
as shown.
©2015 EMS Security Group Ltd. All rights reserved
www.acornfiresecurity.com
Example shown:
FC-323-CA1
FC-171-001
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
63mm
THIS WAY
UP WHEN
WALL
MOUNTING
Cut out section
(shaded area)
www.acornfiresecurity.com
Part No Product Description
FC-171-001 White Wireless Sounder Base Only
FC-171-002 Red Wireless Sounder Base Only
FC-323-CA1 White Ceiling Beacon Only
FC-323-CA2 Red Ceiling Beacon Only
FC-323-WA1 White Wall Beacon Only
FC-323-WA2 Red Wall Beacon Only
See the Specification section for compliance information.
2 Components
1
1
3
Battery Retaining Plate
4 Power Device
Unclip the battery retaining plate from the wireless module.
When fitting / replacing batteries; observe correct polarity,
using only specified batteries.
Connect the power jumper across the PIN header.
SIZE AA
Once powered, reassemble the device.
6 Configuration
The device's loop address is configured within the menu structure
of the Radio Hub.
Refer to the programming manual (Doc Ref: MK98) for full
programming information.
Page 1 of 2
3
2
2
Beacon Wireless Module
4
Mounting Plate
device
unpowered
(pins unlinked)
device
powered
(both pins linked)
Free to download from
www.emsgroup.co.uk
TSD068 Iss 5 10/02/2016
CPR
[2]
[2]
[1]
[1]
[1]
[1]
4
AJM