Global Fire Equipment ADLI V2 FO Programming Manual

Global Fire Equipment // ​ g lobalfire.pt
ADLI V2 FO
Addressable Loop Interface
INSTALLATION / PROGRAMMING MANUAL

GENERAL DESCRIPTION

The ADLI FO V2 is an addressable loop fibre optic interface which allows a conventional ORION / ORION-EX V2
panel to be integrated in any of GFE's analogue addressable systems, allowing the addressable panel to monitor
and control the status of the conventional panel. An 8 way DIL switch is provided to set the module's address and to
configure the advanced features.
There are two assemblies of the ADLI V2 FO: ​ A DLI V2 FO LOOP and ​ A DLI V2 FO ORION​ . Every ORION / ORION-EX V2
panel has to be equipped with one ADLI V2 FO ORION and every link that connects to the loop has to be equipped with one
ADLI V2 FO LOOP.

MAIN FEATURES

● Fast activation response
● Three status LEDs
● Remote sound / Silence alarms
● Remote reset
● Low power consumption
● Automatic conventional panel recognition
● Fault and fire status report
● Different analogue values for zone, panel and supply faults for easier troubleshooting
● Programmable number of addresses to report (for ORION conventional panel)
● Programmable extinguishing, pre-release delay, sounder and disablements status report
using 4 additional addresses reporting as I/Os (ORION-EX V2 panel only)

IMPORTANT SAFETY NOTES

● This equipment must only be installed and maintained by a suitably qualified and technically competent person.
● A basic knowledge and training in the installation of Fire and Extinguish Detection systems is assumed.
● The fire detection system should be designed by a suitably qualified person with reference to the local Regulations
and Guidance from the Fire Officer where applicable.
www.acornfiresecurity.com
www.acornfiresecurity.com
ma_adlifo_01_020000_en_200714
1