Advertisement
Your velucle's engine should be turned
off
while
programming your transmitter. Follow these steps to
program up to three channels:
1. If you have previously programmed a universal
transmitter channel, proceed to Step 2. Otherwise,
hold down the two outside buttons on the universal
transmitter until the red light begins to
flash rapidly
(approximately 20 seconds). Then release the
buttons. This procedure initializes the memory and
erases any previous settings for all three channels.
2. Hold the end of your hand-held transmitter against
the bottom surface of the universal transmitter so
that you can still see the red light.
3.
Decide which one of the three channels you want
to program. Using both hands, press the hand-held
transmitter button and the desired button on the
universal transmitter. Continue to hold both buttons
through Step 4.
light on the universal transmitter flash slowly then
rapidly. The rapid flashing, which could take up to
90 seconds, indicates that the universal transmitter
has been programmed. Release both buttons three
seconds after the light starts to flash rapidly.
4. Hold down both buttons until you see the red
If
you
have trouble programming the universal
transmitter, make sure that you have followed the
directions exactly as described and that the batteries
in
the hand-held transmitter are not dead. If you still
cannot program it, rotate your hand-held transmitter
end over end and try again. The universal transmitter
may not be compatible with a limited number
of older
installations due to legislated changes in transmission
frequencies. If you cannot program the transmitter after
repeated attempts, consult your dealer.
Be sure to keep your original hand-held transmitter in case
you need to erase and reprogram the universal transmitter.
Note to Canadian Owners: During programming, your
hand-held transmitter may stop transmitting after one or
two seconds. If you are programming from one of these
transmitters, you should press and re-press the button
on the hand-held transmitter every two seconds without
ever releasing the button on the universal transmitter.
Release both buttons three seconds after the red light
on the universal transmitter begins to flash rapidly.
Operating the Transmitter
Press and hold the appropriate button on the universal
transmitter. The red light comes on while the signal is
being transmitted.
2-60
Advertisement
